- Information
- Benefits
- Specifications
- Installation Guide
- Data Sheets
- Buy Online
Information
Richco Epoxy High Build Coating is a two-pack solvent free, high build epoxy resin coating for application as a heavy duty coating at a thickness from 200 to 500 microns. The coloured high gloss finish is extremely hard wearing and has good general chemical resistance.
Richco Epoxy High Build Coating has a low-odour during application and provides a sealed, continuous and hygienic floor surface when cured. Richco Epoxy High Build Coating is easily applied and provides a tough, resilient, corrosion and abrasion resistant finish.
- Solvent free
- Hygienic
- Good colour stability
- High gloss finish
- No shrinkage on curing
- Available in a range of colours
Benefits
High Quality Finish
Richco High Build Epoxy Floor Coating provides a smooth gloss, high quality, visually pleasing finish.
Solvent Free
Richco High Build Epoxy Floor Coating can be used in areas where solvent-based products may taint or give off unacceptable odours.
General Maintenance
Richco High Build Epoxy Floor Coating is resistant to the normal range of
industrial cleaners. Do not steam clean or subject to temperatures in excess of 45 °C.
Specifications
Area Coverage
Coverage is approximately 20m per 5.0kg per coat. Please note: porous surfaces,
very light colours and pastel shades may require extra coats.
Unit Size
This product comes in a 5.0 and 15kg unit and is a two part system.
Colour Range
This product is available in the following colours.
 |
 |
 |
| Black | Royal Blue | Baby Blue |
 |
 |
 |
| Rainforest | Khaki Green | Cherry Red |
 |
 |
 |
| Bright Red | Yellow | Buff |
 |
 |
 |
| Tan | Stone | White |
 |
 |
|
| Dark Grey | Light Grey |
Installation Guide
Curing Time
This product will normally cure overnight at 15 °C to accept light foot traffic the next day.
Full chemical and wear resistance is achieved over 7 days (at a minimum constant temp of 15 °C).
Water should not be allowed to lie on the surface for at least 7 days. Avoid washing the surface for 7 days after coating.
Surface Preparation
New concrete should be at least 21 - 28 days old or the moisture less than 5%. The substrate should be clean,
free from laitance, oil, grease or other agents which may impair adhesion. Techniques should include one or more of
the following, depending on how contaminated the substrate is:- acid etching - light mechanical scabbling - blasting - grinding or degreasing.
Priming
A primer is not generally required, epoxy resin coatings can bubble if applied direct to open textured or very porous surfaces.
If your surface is porous, please use Richco Epoxy Primer.
Mixing
Add the full contents of Curing Agent Component B to the contents of Epoxy Resin Component A and mix thoroughly until an even colour is obtained.
Application
Apply by brush or roller, re-coating should take place as soon as possible to achieve good intercoat
adhesion properties, preferably on the following day. If more than one day elapses between coats, abrade the surface lightly with glass paper, before re-coating.
Data Sheets
