- Information
- Benefits
- Specifications
- Installation Guide
- Data Sheets
- Buy Online
Information
Richco Anti Slip UVR Coating is a light stable and hard wearing, slip resistant coating.
This system works by encapsulating anti slip properties in an epoxy coating.
Richco Anti Slip UVR Coating can be applied inside or outside and is ideal for areas that are subject to constant light attack. The coating will not discolour or fade and is ideal for the use in themed areas.
- Anti Slip
- Extremely Hard Wearing
- Large Range of Colours
- Long Lasting
- Light Stable
Benefits
Indoor/Outdoor Use
Richco Anti Slip UVR Coating is ideal for indoor or outdoor use. The coating is available in a large range of colours to suit all applications.
Light Stable
This coating is UV Resistant and provides light stable properties. This ensures the coating will not fade or discolour if exposed to natural or artifical light for extended periods of time.
Anti Slip
Richco Anti Slip UVR Coating has aggregate incorporated between the epoxy coatings. It provides the most hard wearing and long lasting non slip coating.
Specifications
Area Coverage
Sold as a 20 square metre kit.
Unit Size
Sold as a 20 square metre kit.
Colour Range
This product is available in the following colours.
 |
 |
 |
| Black | Royal Blue | Baby Blue |
 |
 |
 |
| Rainforest | Khaki Green | Cherry Red |
 |
 |
 |
| Bright Red | Yellow | Buff |
 |
 |
 |
| Tan | Stone | White |
 |
 |
|
| Dark Grey | Light Grey |
Installation Guide
Curing Time
This product will normally cure overnight at 15°C to accept light foot traffic the next day. Full chemical and wear resistance is achieved over 7 days (at a minimum constant temp of
15°C). Water should not be allowed to lie on the surface for at least 7 days. Avoid washing the surface for 7 days after coating.
Surface Preparation
New concrete should be at least 21 - 28 days old or the moisture less than 5%. The substrate should be clean, free from laitance, oil, grease or other agents which may impair adhesion. Techniques should include one or more of the following, depending on how contaminated the substrate is:- acid etching - light mechanical scabbling - blasting - grinding or degreasing.
Priming
A primer is not generally required, epoxy resin coatings can bubble if applied direct to open textured or very porous surfaces. If your surface is porous, please use Richco Epoxy Primer.
Mixing
Add the full contents of Curing Agent Component B to the contents of Epoxy Resin Component A and mix thoroughly until an even colour is obtained.
Application
Apply by brush or roller in one even coat. Hand scatter aggregate onto the wet coating. Allow the aggregate to dry and settle in place for approximately one hour before applying another coat. Re coat within one hour. Two top coats are normally required to provide the best finish.
Data Sheets
