- Information
- Benefits
- Specifications
- Installation Guide
- Data Sheets
- Buy Online
Information
Richco Asphalt Paint is a high quality, waterbased acrylic coating with slip resistant qualities for asphalt surfaces.
This system is a quick and simple one coat application. Ideal for the application in childrens playgrounds and low traffic areas.
- Anti Slip Paint
- For Use on Asphalt and Similar
- Range of Colours
- Quick and Simple to Use
Benefits
Indoor/Outdoor Use
Richco Asphalt Paint is ideal for indoor or outdoor use on surfaces where a degree of slight slip resistance is required.
Quick & Simple
Richco Asphalt Paint is applied by brush or roller to achieve a fresh, new anti slip surface to asphalt surfaces.
Ideal Applactions
Richco Asphalt Paint is ideal to brighten walkways and cycle ways. It is a popular choice for playgrounds at schools and nurseries.
Specifications
Area Coverage
Coverage area is approximatley 15m per coat per 5kg depending on the texture of the substrate. One coat is normally required.
Unit Size
This product comes in a 5kg unit. Richco Asphalt Paint is a one part anti slip paint.
Colour Range
This product is available in the following colours.
 |
 |
 |
| Dark Blue | Bright Blue | Spring Green |
 |
 |
 |
| Terracotta | Red | Yellow |
 |
||
| Tan |
Installation Guide
Curing Time
This product will normally cure in 2 - 4 hours hours at 15°C to accept light foot traffic. Full wear resistance is achieved over 5 days (at a minimum constant temp of 15°C). Water should not be allowed to lie on the surface for at least 5 days.
Surface Preparation
The substrate should be clean, sound, and free of friable material, preferably dry, but certainly to the extent that moisture does not glisten on the surface, and the substrate temperature should be between 5°C and 25°C. Not to be applied if there is salt contamination or frost.
Mixing
Ensure Richco Asphalt Paint is thoroughly mixed with a wide bladed tool until an even colour is obtained and the fine aggregate is dispersed evenly into the paint.
Application
Apply an even coat using a meduim pile roller while avoiding applying to thick. One coat is all that is normally required, although a second coat may be needed on very porous or rough surfaces. The second coat should be applied after 1 hour.
