Information

Richco Anti Slip Wood Deck is specially formulated for the application onto wooden decking substrates. It provides an attractive, hardwearing, low maintenance, anti-slip surface, whilst preserving the appearance of wooden decking.

Richco Anti Slip Wood Deck is a decorative anti slip decking system, which can be applied onto a wide range of wooden surfacing including decking areas, bridges, walkways and ramps etc.

Benefits

Typical Applications
Richco Anti Slip Wood Deck is ideal for application onto wooden decking which can become slippery when wet.

Anti Slip
Richco Anti Slip Wood Deck System provides a hardwearing, durable surface that offers an anti slip finish. This system is ideal for making slippery decking safe.

Fast Drying
This system is fast drying (usually within 2 hours). This makes Richco Anti Slip Wood Deck ideal for people looking for less down time.

Appearance
Richco Anti Slip Wood Deck preserves the appearance and creates a feature of the original wooden decking.

Installation Guide

Curing Time
This product will normally cure in 2 hours at 15°C to accept light foot traffic. Full wear resistance is achieved over 7 days (at a minimum constant temp of 15°C). Water should not be allowed to lie on the surface for at least 7 days.

Surface Preparation
The substrate should be clean, sound, and free of friable material, preferably dry, but certainly to the extent that moisture does not glisten on the surface, and the substrate temperature should be between 5°C and 25°C. A suitable area for mixing should be set aside and protected from splash and spillage with a plastic sheet. All free edges, fixtures, drainage gullies and gratings etc should be taped over to mask edges, prevent accidental ingress of resin and especially aggregate.

Mixing
Richco Surface Dressing is specially designed, three component system. Mixing should take place by vigorous stirring of the A component for one minute, stopping stirring, adding the other two components and continuing to stir until mixed. Full mixing should take no more than 30 seconds with the correct equipment. The mixed material remains in a mobile, liquid form for approximately 10 minutes, after which a light gel is formed (lasting approximately 15 minutes). The material then sets into a soft solid.

Application
The complete mix should be emptied onto the area (Do not leave material in bulk in the bucket as this will only shorten the pot-life) and spread evenly using a serrated squeegee to achieve a uniform thickness governed by the aggregate size. As soon as the resin has been spread uniformly, the aggregate must be applied to the resin surface, blinding it to excess to ensure complete coverage. Once the resin has cured, the excess aggregate can be swept or vacuumed off and reused if clean and uncontaminated. Tape should be removed when the resin has started its initial cure and no longer flows, but before full cure is reached. It is usually safe to remove the tape 30 minutes after resin application unless the ambient temperature is very cold in which case it will be longer.

Data Sheets