- Information
- Benefits
- Specifications
- Installation Guide
- Data Sheets
- Buy Online
Information
Richco Stone Carpet is a resin bound stone system that produces an attractive internal floor, which is hardwearing and easy to maintain.
Richco Stone Carpet provides a smooth and decorative finish which is suitable for the application indoors for retail outlets, reception areas, offices and themed areas etc.
- Indoor Use
- Bespoke Installations
- Decorative Looking Finish
- Low Maintenance
Benefits
Typical Applications
Richco Stone Carpet is suitable for the application in retail outlets, reception areas, offices, kitchens and themed areas.
Hard Wearing
Richco Stone Carpet provides a hard wearing, durable surface whilst maintaining its decorative and attractice appearance.
Bespoke Installations
Richco Stone Carpet can incorporate logos, patterns and designs which can be specifically designed and installed for each particular project, thereby creating bespoke installations for individual needs.
UV Stable
This system uses a clear UV stable resin binder to ensure the system does not discolour over time due to constant artifical and natural light exposure.
Specifications
Area Coverage
Sold as a 20 square metre kit.
Unit Size
Sold as a 20 square metre kit.
Colour Range
This product is available in the following colours.
 |
 |
 |
| Calcined Flint White | Brittany Bronze | Gayanan Bauxite |
 |
 |
 |
| DKI Quartz | Grey Daltex | Chinese Bauxite |
 |
 |
|
| Autumn Gold | Red Terracotta |
Installation Guide
Curing Time
This product is fit for foot traffic after approximately 4 hours. Full properties will develop in four to five days. Water should not be allowed to lie on the surface for at least 7 days.
Aggregates
Richco Stone Carpet should only be used with dry aggregate. The bond strength of the binder will be reduced if damp aggregate is used and excessive foaming will result. Aggregate which has become damp should be dried before use.
Surface Preparation
Richco recommends the application of Richco Stone Carpet onto a concrete substrates.
Mixing
Components A+B should be mixed with the aggregate in a forced action mixer. Whilst coating the aggregate care should be taken not to over mix, since certain aggregates can be ground to dust by the action of the mixer causing the binder film to become cloudy. Mixing is complete when a uniform coating covers all the aggregate (usually 30 seconds to one minute).
Application
The mixed aggregate is applied to the surface by trowel. A lightweight whacker plate or beam screeder can be used for larger areas. Unless coating a solid substrate (e.g. concrete), depths of less than 25mm should not be used if the surface is to be subject to pedestrian traffic and 40mm for vehicular traffic. In general, five times the size of the largest aggregate within the mix should be considered as a minimum.
The mixed material remains in a mobile form for approximately 30 to 40 minutes depending on the ambient temperature.
Data Sheets
