Information

Richco Solid Flake Flooring is a decorative floor system that provides an attractive and durable finished surface. The finished system has the colour and texture of the flake.

This flooring system is ideal for application in showrooms, industrial warehouses, function rooms, garages, bathrooms etc. It is ideal where an aesthetically pleasing surface is required.

Benefits

High Quality Finish
Richco Solid Flake Flooring provides an attractive and easy to clean surface. The solid flake provides a uniqie surface as well as a high quality surface.

Anti Slip
Richco Solid Flake Flooring not only provides a decorative surface, it is anti slip.

Solvent Free
Being solvent free, this product is formulated to be virtually odourless.

Easy to Clean
Richco Solid Flake Flooring is resistant to the normal range of industrial cleaners. Do not steam clean or subject to temperatures in excess of 45°C.

Installation Guide

Curing Time
This product will normally cure overnight at 15 °C to accept light foot traffic the next day. Full chemical and wear resistance is achieved over 7 days (at a minimum constant temp of
15 °C). Water should not be allowed to lie on the surface for at least 7 days. Avoid washing the surface for 7 days after coating.

Surface Preparation
New concrete should be at least 21-28 days old or the moisture less than 5%. The substrate should be clean, free from laitance, oil, grease or other agents which may impair adhesion. Techniques should include one or more of the following, depending on how contaminated the substrate is:- acid etching - light mechanical scabbling - blasting - grinding or degreasing.

Priming
A primer is not generally required, epoxy resin coatings can bubble if applied direct to open textured or very porous surfaces. If your surface is porous, please use Richco Epoxy Primer.

Mixing
Add the full contents of Curing Agent Component B to the contents of Epoxy Resin Component A and mix thoroughly until an even colour is obtained. A low speed paddle mixer is required when mixing epoxy resins.

Application
Apply by brush or roller, re-coating should take place as soon as possible to achieve good intercoat adhesion properties, preferably on the following day. If more than one day elapses between coats, abrade the surface lightly with glass paper, before re-coating. Whilst the coating is still wet use spiked shoes to walk on the wet resin, hand scatter the flake on top to flood the wet resin. Once the resin has cured, sweep away any excess flake and apply seal coat.

Data Sheets