- Information
- Benefits
- Specifications
- Installation Guide
- Data Sheets
- Buy Online
Information
Richco Standard Epoxy Coating is a two-pack epoxy resin coating which provides a seamless finish where a hard wearing, chemical, abrasion and impact resistant floor surface is required. Richco Standard Epoxy Coating is often used to re-coat on top of existing high build coatings to give a new lease of life to old systems.
Richco Standard Epoxy Coating is non-toxic, low odour during application and provides a versatile, durable, attractive gloss finish in a range of colours. Special colours can be produced, but may be subject to a surcharge.
Richco Standard Epoxy Coating has exceptional adhesion and is solvent free with a 100% solids content.
- Easy to clean
- Good colour stability
- Suitable for regular disinfecting
- Abrasion resistance
- High gloss, good light reflection
- No shrinkage on curing
Benefits
Wide Range of Uses
Richco Standard Epoxy Floor Coating is an excellent product for general purpose use where easy removal of dust, dirt, oil and grease is needed.
Solvent Free
Richco Standard Epoxy Floor Coating can be used in areas where solvent based products may taint or give off unacceptable odours.
Specifications
Area Coverage
Coverage area is approximately 10m² per 2.5kg per coat. For porous surfaces, very light colours and pastel shades may require extra coats.
Unit Size
This product comes in a 2.5 and 5.0kg unit and is a two part system.
Colour Range
This product is available in the following colours.
 |
 |
 |
| Black | Royal Blue | Baby Blue |
 |
 |
 |
| Rainforest | Khaki Green | Cherry Red |
 |
 |
 |
| Bright Red | Yellow | Buff |
 |
 |
 |
| Tan | Stone | White |
 |
 |
|
| Dark Grey | Light Grey |
Installation Guide
Curing Time
This product will normally cure overnight at 15 °C to accept light foot traffic the next day.
Full chemical and wear resistance is achieved over 7 days (at a minimum constant temp of
15 °C). Water should not be allowed to lie on the surface for at least 7 days. Avoid washing the surface for 7 days after coating.
Surface Preparation
New concrete should be at least 21 - 28 days old or the moisture less than 5%.
The substrate should be clean, free from laitance, oil, grease or other agents, which may impair adhesion.
Techniques should include one or more of the following, depending on how contaminated the substrate is: - acid etching -
light mechanical scabbling - blasting - grinding or degreasing.
Priming
A primer is not generally required,
epoxy resin
coatings can bubble if applied direct to
open textured or very porous surfaces.
Mixing
Add the full contents of Curing Agent Component B to the contents of Epoxy Resin Component A and mix thoroughly until an even colour is obtained.
Application
Apply by brush or roller; re coating should take place as soon as possible to achieve good intercoat
adhesion properties, preferably on the following day. If more than one day elapses between coats,
abrade the surface lightly with glass paper, before re coating.
