- Installation Guide
Richco Marble Effect Flooring provides a unique decorative floor which is ideal for application in themed areas, retail outlets and nightclubs etc.
Richco Marble Effect Flooring is a bespoke system and provides the wow factor. It is in particular a very popular finish when a 'different look' is desired.
- Visually Appealing
- Bespoke & Unique
- Hard wearing & Durable
- Seamless Finish
Richco Marble Effect Flooring provides a decorative swirl effect. The system is bespoke and each application is unique.
Richco Marble Effect Flooring can be used in areas where solvent-based products may taint or give off unacceptable odours.
Richco Marble Effect Flooring is applied at 3mm deep. As with all Richco self levelling products this allows un-even or pitted floors to have an epoxy system applied directly to the surface. This avoids additional repair costs and provides a smooth even finish with just one product.
25kg unit of Richco Marble Effect Flooring will cover approximately 4m @ 3mm deep, 4m @ 3mm deep, 3m @ 4mm deep per unit.
This product comes in a 25kg unit and is a three part system.
This product is available in the following colours.
This product will normally cure overnight at 15°C to accept light foot traffic the next day. Full chemical and wear resistance is achieved over 7 days (at a minimum constant temp of 15 °C). Water should not be allowed to lie on the surface for at least 7 days. Avoid washing the surface for 7 days after coating.
New concrete should be at least 21 - 28 days old or the moisture less than 5%. The substrate should be clean, free from laitance, oil, grease or other agents which may impair adhesion. Techniques should include one or more of the following, depending on how contaminated the substrate is:- acid etching - light mechanical scabbling - blasting - grinding or degreasing.
Floors must be thoroughly sealed with Richco Epoxy Primer prior to the application of Richco Marble Effect Flooring.
Richco Marble Effect Flooring is supplied in pre-weighed packs and to obtain the best results should be mixed in a forced action mixer. Add the curing agent component B to the pigmented epoxy resin component A, mix thoroughly until a uniform colour is formed. Transfer the mixed system to a mixing vessel and slowly add the graded filler component C and continue mixing for 3 - 5 minutes until homogeneous.
Pour the mixed material onto the pre-sealed substrate and spread to the required level by steel trowel. Immediately after steel trowelling use spiked rollers, to aid the release of air.