Specifications

Area Coverage
Coverage area is approximately 5m² per 1L. One good application is normally sufficient.

Drying Time
Richco Rain Repel takes at least 24 hours to develop its maximum waterproofing qualities. Drying time varies depending on the porosity of the surface and weather conditions.

Surface Preparation
Surfaces must be clean, dry and sufficiently porous to allow the Richco Rain Repel to penetrate.
Remove all surface growths by wire brushing. Seal any cracks or joints. Do not use detergents to prepare the surface.

Application
Allways test a small area first and allow to dry. Apply by brush. The surface should be well flooded to give at least 15cm run down. If a second application is required allow 36 hours to lapse before appling the second coat.

Application Tools
Apply Richco Rain Repelp using a brush.

Cleaning Application Tools
Applicators may be cleaned with strong solvents, but it may be more practical to discard applicators.